There are many limiting factors for the angle steel solar mounting bracket. The main reason is that it is limited by the quality of the steel, whether it is good or bad, and it must be drilled during on-site installation. It cannot be ensured that the steel is still as old after drilling. And received corrosion. It can be seen that the angle steel solar mounting bracket urgently needs to be updated in materials, and newer materials are sought to replace the angle steel to ensure that it is not vulnerable to corrosion after drilling. Among them, special-shaped cold-formed thin-walled steel is a steel material that can be produced in a large-scale factory and assembled on-site. It has the advantages of saving materials, pre-processing anti-corrosion, and improving efficiency and life. Special-shaped cold-formed thin-walled steel support has become a new type of solar steel mounting structure support in our country.
The on-site installation of the factory prefabricated integral steel bracket is also relatively simple, as long as the on-site assembly is carried out according to the module of the bracket, which greatly improves the construction efficiency, and is often used in large-scale power stations. This new type of solar steel mounting structure bracket has high requirements for materials and installation