Stop working in stormy weather. Solar cell modules can be caught in the wind and make you fall.
Solar cell modules that have never been on one step or sitting on the glass surface. The glass can break, causing shock or physical injury. The module can also stop generating electricity.
Always use components to supply additional solar cell module brackets. The use of weaker parts, such as screws that are too short, is dangerous and may cause the solar module or up and down.
Always use the prescribed tools. The solar cell module or installation may fall if the installation is not strong enough, for example when the parts are not tightened enough.
No parts will be modified or cut. This is dangerous. There is no guarantee of safety.
The product should install and maintain talent. Prevent unauthorized personnel from staying away from the solar module
Point check
Determine on-site installation of wind loads. Please check with your local building and safety department for special requirements. Ensure that the roof structure can support the installation of photovoltaic arrays caused by live and dead loads.
Install solar cell modules facing south, if possible. It is also possible to install something, although the amount of electricity generated will be lower.
installation steps
Determine the location of the roof hook according to your design.
Roof hooks shall not be pressed against roof tiles. Make it flat. If necessary, shim the roof hook with wood.
If necessary, use an angle grinder and hammer cut concave tiles to cover the point where the roof hook is passed. (Warning! Fixed roof hook ladders cannot be used, this extreme point load may damage the tile below.
Install the track roof hook. Your tracks consist of different lengths, always starting with the shortest piece. The mounting rails are loose on the roof and use t-screw.
Mounting fixture
Install joints to connect multiple rails together. Pre-assembled rails on the rear side of sliding engagement. Secure the first bolt. Then slide down the rail to splice it. When coming together, tighten the bolts. The connection is complete. The widening gap is suggested in rail joints. Leave a gap, the width of a finger.
Place the bottom row of the first module. The sliding end clamps the module and the tie. Install the middle clip at the end of the clip.
Clip installation
Install the module by sliding down one module. Speed up the middle clip. Install other components and clip in this way. Even keep the module.